5 notes you need know when install valve

You know our company is an auto tools manufacturer, we can provide high qualty tools to meet your demand. Today, I tell you 5 notes you need know when install valve.

1. Hand wheels, handle and drive mechanism for lifting are not allowed to use, and forbid the collision.

2. Gate Valve should be mounted vertically.

3. With a bypass valve to open the bypass valve opening should be preceded.

4. With the valve drive mechanism, install the required product specification.

5. If the valve switch is used frequently lubrication at least once a month.

How To Detail Your Car's Engine?

Engine detailing is nothing more than cleaning the exterior of the engine and the engine compartment, and applying dressing to protect and beautify the engine. It's very easy to do, and requires no more than 45 minutes to an hour every couple of months.

When you are ready to remove the degreaser, hose down the entire engine compartment and surrounding surfaces with plenty of water. If you're using a high-pressure nozzle, be careful that you don't get the nozzle too close to the covered electrical connectors. Using auto detailing tools gives you better control and a more even flow than most hose attachments. Allow your engine to air dry for several minutes before using a towel to wipe down all accessible parts. Remove the plastic bags. The heat from the engine will assist in the drying process; however, do not allow the engine to air dry, as this will result in water spots. When dry, start your engine and allow it to run for a few minutes.

6 precautions of air duster gun

Air duster gun is used for washing car. Here are 6 precautions of body washing gun.

1. Must be installed in accordance with the operating instructions before use 1. Operation

2. Body Washing Gun connect compressor required by

3. Keep blowing dust gun clean and free of oil and fouling

4. regularly blow gun for cleaning to prevent the accumulation of a large number of other objects in the blowing dust gun parts above, cleaning, cut off the power.

5. Can not be used in environments containing flammable gases and a lot of dust in

6. Non-professionals can not be repaired without authorization

Do you know Magnetic Tray?

Magnetic Tray system as follows:

1: Role: reflow carrier board used.

2: Scope: This system has focused on a flexible board (FCB), sheet, shed plate, aluminum plate, irregular shape contained in the printing plate red plastic, solder paste printing, SMT placement, reflow process of panels, multi-board production and even increase productivity.

3: made with materials: aluminum plate, steel and high-temperature magnets.

4: Advantages: no-clean, easy operation and long life, good flatness, high temperature stability.

5: The new magnetic reflow tray with vintage contrast silica gel plate

● Stability: Magnetic reflow tray in steel magnetic state of the FPC flattened, physical process, magnetic can increase or decrease according to the requirements, will not change due to factors such as temperature and time, more stable. Silica gel plate by chemical action, will change at a temperature of Time and other conditions, lack of stability. In particular, after a certain time tackiness decrease, and when the viscosity decreased during use of uncleaned. When the FPC reflow causing deformation of the substrate. Affect the quality of welding.

● life: magnetic material used reflow tray, works as a physical process, both high temperature materials, as long as not permanently damage and accident conditions can be used. Silica gel plate during use, the use of chemical processes, silicone materials in the course of aging, the cost is very high.

● Quality: Magnetic reflow tray will not damage when taking FPC board. Silica gel plate during use in order to ensure the smooth FPC has a certain viscosity, but in taking board will take the stick FPC cause difficulties and FPC board deformation